Connect DataImpulse proxies

A plan. After the purchase DataImpulse generates a proxy login and password in the Proxy Access section of its dashboard.

The host name sends your requests to the closest server. DataImpulse also gives a fixed IP address and recommends the name, since addresses can change.

The port decides the kind of connection: 823 rotates the address for HTTP and HTTPS, 824 for SOCKS5, and any port from 10000 to 20000 is sticky, with the address bound to the port for a while.

Settings go into the login after two underscores: login__cr.de picks Germany, and a comma adds another country. Several settings are joined with a semicolon.

One address can be kept two ways. A sticky port from 10000 to 20000 holds its address for 1 to 120 minutes, 30 when no interval is set.

Or sessid in the login on port 823 or 824, as in the line below: it connects to one address for about 30 minutes. DataImpulse calls this an alternative to sticky proxies, not a replacement.

For a profile this means its own sticky port or its own session string. The addresses belong to real people: when a device goes offline, DataImpulse replaces the address with another.

The line below is written in the host:port:login:password shape. Put your own login and password in place of the capital letters. The semicolon inside the login stays: ARMANOS reads it as part of the login.

1. 1

   Open Proxies

   The Proxies tab in the left column.

2. 2

   Press Paste a list

   The button above the list.

3. 3

   Paste one line per profile

   Change only the session string from line to line, or give each line its own sticky port.

4. 4

   Press Import

   Lines that could not be read are listed word for word.

The Proxy cell of a profile in the list opens the proxy picker. New proxy as a line… at its bottom takes the same line, shows how it was read, and Add and assign saves it to the library and gives it to that profile.

DataImpulse blocks government websites, banking and payment websites and a list of named services. Some open after identity verification and, for some, a certain spending level.

Target sites are reachable on ports 80, 443, 53, 853, 5060, 5228, 8080, 8090, 8443 and 8888 by default; mail and messaging ports are closed.

Everything about DataImpulse on this page comes from the six DataImpulse documentation pages linked below, checked on 2026-09-28. If DataImpulse changes a host, a port or a parameter, their page is right and this one is late.

ARMANOS is not affiliated with DataImpulse. Prices and plans are on the DataImpulse site.